Crown 2502 Stronghold Wood Adhesive

Application Method: Brush

Spreading Capacity per Coat: 

·       Depends on film thickness applied, type of texture, surface porosity, imperfections, temperature, and wastage during painting. 

·       Generally, 1–3 m²/kg depending on thickness applied.

Surface Preparation & Application 

1. Wood or Boards 

Surface Preparation: 

·       Moisture content of timber should be <15%. 

·       Joints should be smooth and well-fitted. 

·       Surfaces to be bonded must be close-fitting and free from dirt, grease, or any contamination that may interfere with adhesion. 

·       Abrading the surface of the joint before assembling is recommended. 

Application: 

·       Apply a liberal coat of adhesive (2–3 mm thick) with a clean brush to both surfaces to be bonded. 

·       Do not cover too large an area at any one time. 

·       Allow to dry for approximately 2–3 minutes. 

·       Bring both surfaces together. 

·       After completing the joint, hold or clamp with firm but not excessive pressure. 

·       Use a damp cloth to remove any excess wet adhesive. 

·       Allow to fully set for 4–8 hours before removing the pressure. 

·       High bonding power.

·       Quick drying.

·       Water based - environmentally friendly/easy clean up.

·       Low timber staining characteristics.